国产v亚洲v天堂aBlack Sea Medium: For brackish water organisms (16 psu, half-strength nutrients). Combine 500 mL L1?medium and 500 mL dH2O. Autoclave.
L1 (11): For brackish water organisms. Mix 650 mL distilled H2O and 350 mL filtered seawater. Add L1?medium nutrients and autoclave.
L1 (24): For brackish water organisms. Prepare L1-Si medium. To each liter prepared, add 200mL distilled,mix and autoclave.
h/2 Medium: For ammonia loving organisms. Add 1mL of 500mM NH4Cl per liter of L1 medium to give a?final concentration of 500uM ammonia. Autoclave.
L1+ NH4Cl: For organisms do not love ammonia quite as much. Prepare as for L1 medium but omit the silica?and add 300uL of a 500mM NH4Cl per liter of L1 medium to give a final concentration of 166uM ammonia.Autoclave.
L1 agar: To grow algae on agar, prepare 1 liter of L1 medium and dissolve 9g agar (heat and mix). For test?tubes, dispense dissolved agar medium into tubes, autoclave, and then cool with tubes slanted at an angle. For?Petri plates, autoclave in a flask, cool almost to the gelling point, and then aseptically dispense into sterile Petri?plates. Note: The agar concentration can be varied to produce softer or firmer substrates.
L1 – Si: Prepare as for L1 medium but omit Na2SiO 3 ? 9H2O. This is preferred over L1 medium for organisms?with no silica requirement because less precipitation forms.
L1 + Se: Extra silicon and selenium are beneficial to some diatom species. Prepare 1 L of L1 medium but use 2?mL of silicate stock, then add 1.0 mL of selenium stock solution (1.29 mg H2SeO 3 /L distilled H2O). Autoclave.
L/10-Si: for more fastidious organisms. Autoclave 1 L of filtered seawater. When cool, aseptically add L1-Si?nutrients at one tenth concentration (i.e., 100uL per L).
L1/25-Si: for even more delicate organisms. This is more than a 1/25 dilution of f/2-Si medium. We autoclave 1?L of seawater in a Teflon-lined bottle. Wait for the autoclaved seawater to cool to room temperature
L1/25-Si + CCMP1320 as food: for growing mixotrophs or heterotrophs. Prepare f/50 and aseptically add?50uL of healthy, moderately dense culture of CCMP1320.
L1m: This medium is used to test for contamination by methylaminotrophic bacteria. To 1L of L1 medium,?add 1 g methylamine ? HCl, mix until dissolved and autoclave.
L1p: This medium is used to test for contamination by non- methylaminotrophic bacteria and fungi. It can also?be used by organisms that require an organic carbon source. To 1 L of L1 medium,add 1 g Bacto-peptone, mix?until dissolves and autoclave.
L1pm: This general medium is used to test for contamination by bacteria and fungi. To 1L of L1 medium add 1g Bacto-peptone and 1 g methylamine · HCl, mix until dissolved and autoclave.
L1 + NPM: For organisms requiring an organic carbon source. Add L1 nutrients to 900 mL of seawater and?autoclave. After cooling, aseptically add 100 mL of organic stock solution (for recipe, see below). Dispense?aseptically into test tubes. Or, you can add sterile NPM to each tube aseptically. We use an approximately 10%?solution of NPM in L1 medium.
Prov: Add 20 mL of a 1:50 dilution of Alkaline Soil Extract for a final volume of 1L of L1-Si medium (see?soil extract recipe below). At NCMA, we use the term Prov whether using a L1 base or a f/2 base.
Prov50, Prov100: see Prov50 medium page Organics Stock Solution